complex connector for cable and panel idc (1.27 mm), crimping sequence configuration of product part no. mating connectors: pcl-g96rm( )+ (see note #1) power contacts: pcl-a-f( ) idc tool: locator plate: mlpt-0001a, hand press: rps-k4 (refer to page tool-16) hand crimping tool: kp-pcl-346f( )n extraction tool: amq-rt2 (refer to page tool-9) idc type (power contact: crimping type) female connector for cable and panel pcl-g96rf( )( )+ pcl-g 96 rf ( ) ( )+ ? series name ? no. of contacts: 96 (20 in a block for signals, 68 in a block for signals and 8 in a block for power) type of contact rm: 1.27 mm pitch signal contacts, idc type, with strain relief, female (awg#28 stranded flat cable) type of key (see note #1) blank : none 1 : key type 1 2 : key type 2 others blank : standard type a : mounting hole diameter: 2.8mm b : 68 contacts in a block for signals, awg#30 stranded flat cable for idc ?? honda japan 24.13 22.86 4.8 2.54 33.6 91 96 103 88 polarity key ( 20 contacts in a block ) pos.#p8 pos.#p7 pos.#p2 pos.#p1 pos.#1 pos.#67 pos.#20 pos.#19 pos.#2 pos.#1 ?3.3 pos.#68 pos.#2 4.4 9.5 30 6.5 2.54 83.82 94.7 85.09 98.7 (68 contacts in a block) (20 contacts in a block) (68 contacts in a block) ? 2.54 5 5 26 3.9 11 29 27 4 10 10 3 2 ? cable housing strain relief 96 95 84.5 12 max m3 (dimension for tapped hole) recommended panel cut-out dimensions (panel thickness: t = 2 mm or less) 29.5 components ? insulator ? power contact signal contact note 1: male and female connectors can be mated each other with same key type. however, a female connector without key can be mated with a male connector with any key. further, when trying to mate a male connector without key and a female connector with key, some adjacent contacts may create a short circuit. others wire wrapping crimping soldering idc press-in smt through hole
|
